루처베르거 호수 주변 최고의 도시 하이킹 & 워킹 코스

루르 강을 따라 아름다운 자전거 도로

You can spend a lot of time here. Large playground. In summer you can often see families playing and/or barbecuing. In the Teaterhof you can also enjoy good home cooking. Check out the city of DN's calendar of events so you don't miss any events

simple shelter Good path!

The three digesters reach a height of 28 m above ground and are sunk 8 m into the ground. The content of one container is 6,000 m³. In the digesters, the organic components of the sludge are largely converted into methane (CH 4 ), carbon dioxide (CO 2 ) and water (H2O) by bacteria while removing oxygen and heating them to 37°C. This process is called "anaerobic sludge stabilization." The average residence time of the sludge in the digesters is 20 days. The methane is collected in a 3,000 m³ low-pressure tank and, after a three-stage treatment process (drying, gas pressure increase, siloxane and sulfur elimination), is converted into electricity in three combined heat and power plants (CHP). The CHPs are gasoline engines that use their power to drive generators. The electrically generated output per CHP is 625 KWel (i.e. a maximum of 1,875 KWel). The total electrically generated output covers around 75% of the electricity requirements of the Düren sewage treatment plant. In addition to the electrically generated energy, the CHP also produces thermal energy (heat) on the same scale. This energy is used to heat the digestion tanks to 37°C and to heat the operating buildings. This combined heat and power system ensures a high level of energy utilization. The effluent from the digestion tanks is collected in a secondary thickener. The secondary thickener serves as a storage tank for sewage sludge dewatering. https://wver.de/wp-content/uploads/2019/11/broschuere_dueren.pdf

Good bike path nice to ride

Always nice to drive.

The route was very easy to drive.

The RurUfer cycle path is a cycle path that runs along the Rur for around 180 kilometers. It begins near the Rur sources at the highest elevation in Belgium, the Botrange in the High Fens, and leads to the mouth of the Maas in Roermond, the Netherlands. In between, the route runs mostly on German territory. At Kalterherberg, the path crosses the Belgian-German border and runs through Monschau on the Obersee and the Rur dam to Heimbach. From there, it continues north through Nideggen and Kreuzau through the Düren district and then through the Heinsberg district. Behind the Effelder Waldsee, the cycle path crosses the German-Dutch border. It ends at the mouth of the Rur in Roermond. The route runs almost exclusively on separate cycle and farm paths. The RurUfer cycle path is part of the NRW cycle network and is signposted with the typical red and white signposts. On the sections in Belgium and the Netherlands, junction-based signage is used.